Mainsail Webcam: Klipper is one of the few 3D printing firmware that natively supports an external camera for monitoring your 3D printer
Getting started with Klipper Mainsail
Setting Up Webcams with Klipper Installation And Update Helper (KIAUH)
This is on a VM, running Ubuntu 20.
Easy Klipper Timelapse Setup Tutorial | Bonus Webcam Focus Calibration
How to reproduce this bug? I installed mainsail os with raspberry pi imager, its a fresh install. As it turns out, the camera module 3 isn’t supported in crowsnest as yet - but someone has created Spyglass to act as a middleware layer allowing you to add a camera into Mainsail. Its purpose is to easily keep an eye on the 3D printer from the distance.
#51 - Klipper FAQ - crowsnest V4 Guide
G-Code Viewer: View a 3D render ….
15K views 1 year ago PARIS. I have not used mainsail before. GitHub - mainsail-crew/crowsnest: Webcam Service for multiple Cams master README Code of conduct GPL-3.
If you set your webcam config to 1280x720 30fps like I do, the webcam is low fps inside of mainsail, but runs a lot smoother if you open a new tab and use :8080 .
This has only been tested on Raspberry Pi OS/MainsailOS so far. KIAUH contains additional features and is recommended for multi-printer setups. Klipper is one of the few 3D printing firmware that natively supports an external camera for monitoring your 3D printer.
(4)
Roboghost
Thursday 9th of May 2024, 10:31:52 PM
It all seems fake to me. Even the polygraph tests
Anssshhh
Tuesday 7th of May 2024, 06:58:24 AM
Wheres the fart bit lol
Shanestan
Saturday 4th of May 2024, 12:30:42 AM
Always lovely!!! Thanks!!!
Ozairquamar
Thursday 2nd of May 2024, 12:36:49 AM
63. Punish for crimes in an exemplary way (5:38)